Samsung Galaxy S6 edge 404SCSCS1CPK1
404SC 1 country

Samsung Galaxy S6 edge 404SCSCS1CPK1 Firmware

Samsung Galaxy S6 edge 404SCSCS1CPK1 is an Android firmware for SBM. It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build 404SCSCU1BPA1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for 404SC is available: 404SCSCU1DQG1.

8.9/10 (28)4,529 times
n/a
OS Version
2016-11-14
First release
other regions until 2016-11-23
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: 404SCSCS1CPK1
    ModelRegionCSC VersionBuild DateRelease dateSizeFile nameDownload
    404SC
    SBM
    		404SCSBM1CPK1 2016-11-23 2016-12-06 1.793 GiB
    404SC_1_20161123161615_vx1xm18udc_fac.zip
    404SC
    SBM
    		SCS1CPK11CPK1 2016-11-14 — — —

    No matching downloads

    How to flash 404SCSCS1CPK1

    • 404SCSCS1CPK1 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for 404SC is available: 404SCSCU1DQG1. Install it instead of 404SCSCS1CPK1 unless you need this exact version. The previous build was 404SCSCU1BPA1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.793 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S6 edge must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy S6 edge running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 3 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S6 edge

    No changelog details available.
    No changelog details available.
    No changelog details available.
    No changelog details available.
    Model firmware by region