SM-A300H 1 country Android 4.4.4 (KitKat)

Samsung Galaxy A3 A300HXXU1ANKO Firmware

Name: Samsung Galaxy A3 (SM-A300H)
Brand: Samsung
Availability: InStock

Samsung Galaxy A3 A300HXXU1ANKO is an Android 4.4.4 (KitKat) firmware for Bangladesh (BNG). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build A300HXXU1ANKM, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-A300H is available: A300HXXS1BSA1.

8.7/10 (452)4,356 times

Android 4.4.4 (KitKat)

OS Version

2014-11-26

Build Date

n/a

Security patch

Countries

CSC codes

Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: A300HXXU1ANKO

Model	Region	CSC Version	Size	File name	Download
SM-A300H	BNG Bangladesh	A300HODD1ANK5	—	—

Device specifications

Launched withAndroid 4.4
Display diagonal11.4 cm (4.5")
Display resolution540 x 960 pixels
Display typeSAMOLED
Processor frequency1.2 GHz
RAM1 GB
Rear camera resolution8 MP
Rear camera typeSingle camera
SIM cardsDual SIM
Battery capacity1900 mAh
Weight110.3 g

How to flash A300HXXU1ANKO

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

A300HXXU1ANKO has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

A300HXXU1ANKO is Android 4.4.4 (KitKat) firmware for Samsung Galaxy A3, released for Bangladesh (BNG). Samsung built it on 2014-11-26.

No. A newer build for SM-A300H is available: A300HXXS1BSA1. Install it instead of A300HXXU1ANKO unless you need this exact version. The previous build was A300HXXU1ANKM.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy A3 must be on bootloader binary 1 or lower.

This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy A3 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 65 other builds of this model use the same binary, so you can switch between them in both directions.