Samsung Galaxy S 3 LTE (Korea KTF) E210KKTUKOA1 Firmware
Samsung Galaxy S 3 LTE (Korea KTF) E210KKTUKOA1 is an Android 4.4.4 (KitKat) firmware for KTF. It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SHV-E210K is available: E210KKTUKOL2.
8.9/10 (470)4,368 times
Android 4.4.4 (KitKat)
OS Version
2015-01-06
Build Date
n/a
Security patch
1
Countries
1
CSC codes
U (30)
Bootloader binary
Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: E210KKTUKNK4
How to flash E210KKTUKOA1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- E210KKTUKOA1 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
E210KKTUKOA1 is Android 4.4.4 (KitKat) firmware for Samsung Galaxy S 3 LTE (Korea KTF), released for KTF. Samsung built it on 2015-01-06.
No. A newer build for SHV-E210K is available: E210KKTUKOL2. Install it instead of E210KKTUKOA1 unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.084 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S 3 LTE (Korea KTF) must be on bootloader binary U (30) or lower.
This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy S 3 LTE (Korea KTF) running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.