Samsung GALAXY S4 E330LKLUDPI2
SHV-E330L 1 country Android 5.0.1

Samsung GALAXY S4 E330LKLUDPI2 Firmware

Samsung GALAXY S4 E330LKLUDPI2 is an Android 5.0.1 firmware for LGT. It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. This is the newest build for SHV-E330L.

9.1/10 (451)8,651 times
Android 5.0.1
OS Version
2016-09-20
Build Date
n/a
Security patch
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: E330LKLUDPI2
    ModelRegionCSC VersionSizeFile nameDownload
    SHV-E330L
    LGT
    		E330LDPI2 — —
    SHV-E330L
    LGT
    		E330LYGTDPI2 — —

    No matching downloads

    How to flash E330LKLUDPI2

    • E330LKLUDPI2 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    E330LKLUDPI2 is Android 5.0.1 firmware for Samsung GALAXY S4, released for LGT. Samsung built it on 2016-09-20.

    Yes. E330LKLUDPI2 is the newest build for SHV-E330L on SamFirm.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GALAXY S4 must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung GALAXY S4 running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary U (30).

    Other builds and changelog for Samsung GALAXY S4

    No changelog details available.
    Model firmware by region