SM-F700N 1 country Android 10

Samsung Galaxy Z Flip F700NTBU1ATB6 Firmware

Name: Samsung Galaxy Z Flip (SM-F700N)
Brand: Samsung
Availability: InStock

Samsung Galaxy Z Flip F700NTBU1ATB6 is an Android 10 firmware for South Korea (KOO). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SM-F700N is available: F700NKOS4KWL1 https://samfirm.shop/build/F700NKOS4KWL1.

9.2/10 (453)4,382 times

Android 10

OS Version

2020-02-07

Build Date

n/a

Security patch

Countries

CSC codes

Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Z Flip use bootloader binary 4 (latest: F700NKOS4KWL1). If your device already runs binary 4, this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: F700NTBU1ATB6

Model	Region	CSC Version	Size	File name	Download
SM-F700N	KOO South Korea	F700NOKT1ATB6	—	—

Device specifications

Launched withAndroid 10.0
Display diagonal17 cm (6.7")
Display resolution2636 x 1080 pixels
Display typeDynamic AMOLED
RAM8 GB
Rear camera resolution12 MP
Rear camera typeDual camera
Battery capacity3300 mAh
Weight183 g

Specifications of SM-F700F, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

How to flash F700NTBU1ATB6

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

F700NTBU1ATB6 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

F700NTBU1ATB6 is Android 10 firmware for Samsung Galaxy Z Flip, released for South Korea (KOO). Samsung built it on 2020-02-07.

No. A newer build for SM-F700N is available: F700NKOS4KWL1. Install it instead of F700NTBU1ATB6 unless you need this exact version.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Z Flip must be on bootloader binary 1 or lower.

This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Z Flip running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 19 other builds of this model use the same binary, so you can switch between them in both directions.