Samsung Galaxy Z Flip 5G F707NKSU1ATGH Firmware
Samsung Galaxy Z Flip 5G F707NKSU1ATGH is an Android 10 firmware for South Korea (KOO, KTC, LUC, SKC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SM-F707N is available: F707NKSS5KXH1.
9.0/10 (452)26,202 times
Android 10
OS Version
2020-07-30
Build Date
n/a
Security patch
1
Countries
4
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy Z Flip 5G use bootloader binary 5 (latest: F707NKSS5KXH1). If your device already runs binary 5, this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
No matching downloads
Device specifications
- Launched withAndroid 10.0
- Display diagonal17 cm (6.7")
- Display resolution2636 x 1080 pixels
- Display typeDynamic AMOLED
- RAM8 GB
- Rear camera resolution12 MP
- Rear camera typeDual camera
- Battery capacity3300 mAh
- Weight183 g
Specifications of SM-F707B, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.
How to flash F707NKSU1ATGH
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- F707NKSU1ATGH has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
F707NKSU1ATGH is Android 10 firmware for Samsung Galaxy Z Flip 5G, released for South Korea (KOO, KTC, LUC, SKC). Samsung built it on 2020-07-30.
No. A newer build for SM-F707N is available: F707NKSS5KXH1. Install it instead of F707NKSU1ATGH unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 5.787 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Z Flip 5G must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Z Flip 5G running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 5 other builds of this model use the same binary, so you can switch between them in both directions.