SM-G3502 1 country
Samsung Galaxy Core Plus G3502ZNUANG1 Firmware
Samsung Galaxy Core Plus G3502ZNUANG1 is an Android firmware for China (CHU). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build G3502ZNUAND1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for SM-G3502.
9.1/10 (451)4,347 times
n/a
OS Version
2014-08-05
Build Date
n/a
Security patch
1
Countries
1
CSC codes
U (30)
Bootloader binary
Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: G3502ZNUANG1
Device specifications
- Launched withAndroid 4.2
- Display diagonal10.9 cm (4.3")
- Display resolution480 x 800 pixels
- Display typeTFT
- RAM0.75 GB
- Rear camera resolution5 MP
- Rear camera typeSingle camera
- Battery capacity1800 mAh
- Weight132.5 g
Specifications of SM-G350, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.
How to flash G3502ZNUANG1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- G3502ZNUANG1 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
Yes. G3502ZNUANG1 is the newest build for SM-G3502 on SamFirm. The previous build was G3502ZNUAND1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 619.899 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Core Plus must be on bootloader binary U (30) or lower.
This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Core Plus running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.