SM-G891A 1 country

Samsung Galaxy S7 Active G891AUCS6CSI2 Firmware

Samsung Galaxy S7 Active G891AUCS6CSI2 is an Android firmware for United States (ATT). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SM-G891A is available: G891AUCU6CTB1.

9.3/10 (26)106 times
n/a
OS Version
2019-10-09
Build Date
n/a
Security patch
1
Countries
1
CSC codes
6
Bootloader binary

Bootloader binary 6. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: G891AUCS6CSI2
    ModelRegionCSC VersionSizeFile nameDownload
    SM-G891A
    ATT United States
    		G891AATT6CSI2 2.519 GiB
    SM-G891A_1_20191009205140_65mtgls0hk_fac.zip

    No matching downloads

    How to flash G891AUCS6CSI2

    • G891AUCS6CSI2 has bootloader binary 6. Your device must run binary 6 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for SM-G891A is available: G891AUCU6CTB1. Install it instead of G891AUCS6CSI2 unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 2.519 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S7 Active must be on bootloader binary 6 or lower.

    This build uses bootloader binary 6. It can be flashed on a Samsung Galaxy S7 Active running binary 6 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S7 Active

    No changelog details available.
    No changelog details available.
    Model firmware by region