Samsung Galaxy S6 Edge+ G928W8VLU1AOGD Firmware
Samsung Galaxy S6 Edge+ G928W8VLU1AOGD is an Android 5.1.1 firmware for Canada (ESK, GLW, XAC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SM-G928W8 is available: G928W8VLU6CVG1.
9.1/10 (452)13,125 times
Android 5.1.1
OS Version
2015-07-16
Build Date
n/a
Security patch
1
Countries
3
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy S6 Edge+ use bootloader binary 6 (latest: G928W8VLU6CVG1). If your device already runs binary 6, this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: G928W8VLU1AOGD
No matching downloads
Device specifications
- Launched withAndroid 5.1
- Display diagonal14.5 cm (5.7")
- Display resolution2560 x 1440 pixels
- Display typeSAMOLED
- RAM4 GB
- Rear camera resolution16 MP
- Rear camera typeSingle camera
- Battery capacity3000 mAh
- Weight153 g
Specifications of SM-G928W, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.
How to flash G928W8VLU1AOGD
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- G928W8VLU1AOGD has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
G928W8VLU1AOGD is Android 5.1.1 firmware for Samsung Galaxy S6 Edge+, released for Canada (ESK, GLW, XAC). Samsung built it on 2015-07-16.
No. A newer build for SM-G928W8 is available: G928W8VLU6CVG1. Install it instead of G928W8VLU1AOGD unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S6 Edge+ must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy S6 Edge+ running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary 1.