Samsung Galaxy Tab 2 10.1 (AT&T) I497UMAMB1
SGH-I497 1 country

Samsung Galaxy Tab 2 10.1 (AT&T) I497UMAMB1 Firmware

Samsung Galaxy Tab 2 10.1 (AT&T) I497UMAMB1 is an Android firmware for Mexico (TCE). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I497UMAMA2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SGH-I497 is available: I497UMBND2.

9.4/10 (473)8,749 times
n/a
OS Version
2013-02-12
Build Date
n/a
Security patch
1
Countries
1
CSC codes
M (22)
Bootloader binary

Bootloader binary M (22). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    ModelRegionCSC VersionMODEM/CP VersionSizeFile nameDownload
    SGH-I497
    TCE Mexico
    		I497UMAMB1I497TCEAMB1 — —
    SGH-I497
    TCE Mexico
    		I497TCEAMB1I497UMAMB1 — —

    No matching downloads

    How to flash I497UMAMB1

    • I497UMAMB1 has bootloader binary M (22). Your device must run binary M (22) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for SGH-I497 is available: I497UMBND2. Install it instead of I497UMAMB1 unless you need this exact version. The previous build was I497UMAMA2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab 2 10.1 (AT&T) must be on bootloader binary M (22) or lower.

    This build uses bootloader binary M (22). It can be flashed on a Samsung Galaxy Tab 2 10.1 (AT&T) running binary M (22) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 4 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Tab 2 10.1 (AT&T)

    No changelog details available.
    Model firmware by region