SGH-I537 1 country

Samsung Galaxy S4 Active (AT&T) I537UBUAMG2 Firmware

Name: Samsung Galaxy S4 Active (AT&T) (SGH-I537)
Brand: Samsung
Availability: InStock

Samsung Galaxy S4 Active (AT&T) I537UBUAMG2 is an Android firmware for Mexico (TCE). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SGH-I537 is available: I537UBUCOE1 https://samfirm.shop/build/I537UBUCOE1.

9.1/10 (472)4,393 times

n/a

OS Version

2013-07-10

Build Date

n/a

Security patch

Countries

CSC codes

U (30)

Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: I537UBUAMG2

Model	Region	CSC Version	Release date	Size	File name	Download
SGH-I537	TCE Mexico	I537TCEAMG2	2013-08-28	1.444 GiB	SGH-I537_TCE_1_20140527180410_ebs5ft44ff_fac.zip

How to flash I537UBUAMG2

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

I537UBUAMG2 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

No. A newer build for SGH-I537 is available: I537UBUCOE1. Install it instead of I537UBUAMG2 unless you need this exact version.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.444 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S4 Active (AT&T) must be on bootloader binary U (30) or lower.

This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy S4 Active (AT&T) running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 7 other builds of this model use the same binary, so you can switch between them in both directions.