Samsung Galaxy Note LTE (Rogers) I717RUXLF4 Firmware
Samsung Galaxy Note LTE (Rogers) I717RUXLF4 is an Android 4.1.2 firmware for Canada (RWC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SGH-I717R is available: I717RUXUMB1.
9.3/10 (451)4,235 times
Android 4.1.2
OS Version
n/a
Build Date
n/a
Security patch
1
Countries
1
CSC codes
U (30)
Bootloader binary
Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy Note LTE (Rogers) use bootloader binary X (33) (latest: I717RUXUMB1). If your device already runs binary X (33), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: I717RUXLF4
How to flash I717RUXLF4
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- I717RUXLF4 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
I717RUXLF4 is Android 4.1.2 firmware for Samsung Galaxy Note LTE (Rogers), released for Canada (RWC).
No. A newer build for SGH-I717R is available: I717RUXUMB1. Install it instead of I717RUXLF4 unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note LTE (Rogers) must be on bootloader binary U (30) or lower.
This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Note LTE (Rogers) running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.