Samsung Galaxy S 2 I9100TDCLSD
GT-I9100T 1 country

Samsung Galaxy S 2 I9100TDCLSD Firmware

Samsung Galaxy S 2 I9100TDCLSD is an Android firmware for Thailand (THL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for GT-I9100T is available: I9100TJKLP1.

8.7/10 (473)4,481 times
n/a
OS Version
2013-05-07
Build Date
n/a
Security patch
1
Countries
1
CSC codes
D (13)
Bootloader binary

Bootloader binary D (13). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy S 2 use bootloader binary J (19) (latest: I9100TJKLP1). If your device already runs binary J (19), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: I9100TDCLSD
    ModelRegionCSC VersionSizeFile nameDownload
    GT-I9100T
    THL Thailand
    		I9100TTHLLSD — —

    No matching downloads

    How to flash I9100TDCLSD

    • I9100TDCLSD has bootloader binary D (13). Your device must run binary D (13) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for GT-I9100T is available: I9100TJKLP1. Install it instead of I9100TDCLSD unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S 2 must be on bootloader binary D (13) or lower.

    This build uses bootloader binary D (13). It can be flashed on a Samsung Galaxy S 2 running binary D (13) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 5 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S 2

    No changelog details available.
    Model firmware by region