Samsung Galaxy S 2 LTE I9210TDVLP7 Firmware
Samsung Galaxy S 2 LTE I9210TDVLP7 is an Android 4.0.4 (Ice) firmware for Australia (TEL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for GT-I9210T is available: I9210TDVOI1.
9.3/10 (470)4,394 times
Android 4.0.4 (Ice)
OS Version
2012-11-08
Build Date
n/a
Security patch
1
Countries
1
CSC codes
D (13)
Bootloader binary
Bootloader binary D (13). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: I9210TDVLP5
How to flash I9210TDVLP7
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- I9210TDVLP7 has bootloader binary D (13). Your device must run binary D (13) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
I9210TDVLP7 is Android 4.0.4 (Ice) firmware for Samsung Galaxy S 2 LTE, released for Australia (TEL). Samsung built it on 2012-11-08.
No. A newer build for GT-I9210T is available: I9210TDVOI1. Install it instead of I9210TDVLP7 unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 439.488 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S 2 LTE must be on bootloader binary D (13) or lower.
This build uses bootloader binary D (13). It can be flashed on a Samsung Galaxy S 2 LTE running binary D (13) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.