Samsung Galaxy S 3 (China Anycall) I939ZTCND2
SCH-I939 1 country

Samsung Galaxy S 3 (China Anycall) I939ZTCND2 Firmware

Samsung Galaxy S 3 (China Anycall) I939ZTCND2 is an Android firmware for APT. It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SCH-I939 is available: I939KEUFNK1.

9.2/10 (471)4,266 times
n/a
OS Version
2014-05-21
Build Date
n/a
Security patch
1
Countries
1
CSC codes
T (29)
Bootloader binary

Bootloader binary T (29). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy S 3 (China Anycall) use bootloader binary U (30) (latest: I939KEUFNK1). If your device already runs binary U (30), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: I939ZTCND2
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SCH-I939
    APT
    		I939APTCND2 2014-05-21 860.627 MiB
    SCH-I939_1_20151124134813_ym7wbpj8d6_fac.zip

    No matching downloads

    How to flash I939ZTCND2

    • I939ZTCND2 has bootloader binary T (29). Your device must run binary T (29) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for SCH-I939 is available: I939KEUFNK1. Install it instead of I939ZTCND2 unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 860.627 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S 3 (China Anycall) must be on bootloader binary T (29) or lower.

    This build uses bootloader binary T (29). It can be flashed on a Samsung Galaxy S 3 (China Anycall) running binary T (29) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary T (29).

    Other builds and changelog for Samsung Galaxy S 3 (China Anycall)

    No changelog details available.
    No changelog details available.
    No changelog details available.
    Model firmware by region