Samsung Galaxy S 2 (WiMAX) ISW11SCKDMP9
ISW11SC 1 country

Samsung Galaxy S 2 (WiMAX) ISW11SCKDMP9 Firmware

Samsung Galaxy S 2 (WiMAX) ISW11SCKDMP9 is an Android firmware for Japan (KDI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for ISW11SC is available: ISW11SCKDNY3.

9.3/10 (472)4,332 times
n/a
OS Version
2013-09-27
Build Date
n/a
Security patch
1
Countries
1
CSC codes
K (20)
Bootloader binary

Bootloader binary K (20). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: ISW11SCKDMP9
    ModelRegionCSC VersionSizeFile nameDownload
    ISW11SC
    KDI Japan
    		ISW11SCKDIMP9 — —

    No matching downloads

    How to flash ISW11SCKDMP9

    • ISW11SCKDMP9 has bootloader binary K (20). Your device must run binary K (20) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for ISW11SC is available: ISW11SCKDNY3. Install it instead of ISW11SCKDMP9 unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S 2 (WiMAX) must be on bootloader binary K (20) or lower.

    This build uses bootloader binary K (20). It can be flashed on a Samsung Galaxy S 2 (WiMAX) running binary K (20) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S 2 (WiMAX)

    No changelog details available.
    No changelog details available.
    No changelog details available.
    Model firmware by region