SM-J337A 1 country Android 9

Samsung Galaxy J3 Top J337AUCSCBUB1 Firmware

Name: Samsung Galaxy J3 Top (SM-J337A)
Brand: Samsung
Availability: InStock

Samsung Galaxy J3 Top J337AUCSCBUB1 is an Android 9 firmware for United States (ATT). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build J337AUCSBBTI1: bootloader binary raised from B (11) to C (12), so after installing it there is no way back to older builds. A newer build for SM-J337A is available: J337AUCSDBUI1.

9.3/10 (29)178 times

Android 9

OS Version

2021-03-02

Build Date

n/a

Security patch

Countries

CSC codes

C (12)

Bootloader binary

Bootloader binary C (12). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy J3 Top use bootloader binary D (13) (latest: J337AUCSDBUI1). If your device already runs binary D (13), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: J337AUCSCBUB1

Model	Region	CSC Version	Size	File name	Download
SM-J337A	ATT United States	J337AATTCBUB1	2.225 GiB	SM-J337A_1_20210302154305_2m4lb6u3bh_fac.zip

How to flash J337AUCSCBUB1

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

J337AUCSCBUB1 has bootloader binary C (12). Your device must run binary C (12) or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

J337AUCSCBUB1 is Android 9 firmware for Samsung Galaxy J3 Top, released for United States (ATT). Samsung built it on 2021-03-02.

No. A newer build for SM-J337A is available: J337AUCSDBUI1. Install it instead of J337AUCSCBUB1 unless you need this exact version. The previous build was J337AUCSBBTI1.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 2.225 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy J3 Top must be on bootloader binary C (12) or lower.

This build uses bootloader binary C (12). It can be flashed on a Samsung Galaxy J3 Top running binary C (12) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.