Samsung Galaxy J5 J500FZHU1APB1 Firmware
Samsung Galaxy J5 J500FZHU1APB1 is an Android 5.1.1 (Lollipop) firmware for Hong Kong SAR China (TGY). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build J500FXXU1APA5: Android updated from Android 5.1.1 (Marshmallow) to Android 5.1.1 (Lollipop). A newer build for SM-J500F is available: J500FXXU1BSK2.
9.0/10 (452)4,267 times
Android 5.1.1 (Lollipop)
OS Version
2016-02-25
Build Date
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: J500FZHU1APB1
Device specifications
- Display diagonal12.7 cm (5")
- Display resolution1280 x 720 pixels
- Display typeSAMOLED
- Processor frequency1.2 GHz
- RAM1.5 GB
- Rear camera resolution13 MP
- Rear camera typeSingle camera
- Battery capacity2600 mAh
- Weight146 g
What's new in J500FZHU1APB1
- apply the new vibration mode
- Apply the Andriod regular security patch.
How to flash J500FZHU1APB1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- J500FZHU1APB1 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
J500FZHU1APB1 is Android 5.1.1 (Lollipop) firmware for Samsung Galaxy J5, released for Hong Kong SAR China (TGY). Samsung built it on 2016-02-25.
No. A newer build for SM-J500F is available: J500FXXU1BSK2. Install it instead of J500FZHU1APB1 unless you need this exact version. The previous build was J500FXXU1APA5.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 968.818 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy J5 must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy J5 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 67 other builds of this model use the same binary, so you can switch between them in both directions.