Samsung Galaxy Note II L900VPUCNE2
SPH-L900 1 country Android 4.4.2 (KitKat)

Samsung Galaxy Note II L900VPUCNE2 Firmware

Samsung Galaxy Note II L900VPUCNE2 is an Android 4.4.2 (KitKat) firmware for United States (SPR). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build L900VPUBMK4: Android updated from Jelly(Android Bean) to Android 4.4.2 (KitKat). A newer build for SPH-L900 is available: L900VPUCOH3.

8.8/10 (472)4,397 times
Android 4.4.2 (KitKat)
OS Version
2014-05-07
Build Date
n/a
Security patch
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: L900VPUCNE2
    ModelRegionCSC VersionSizeFile nameDownload
    SPH-L900
    SPR United States
    		L900SPTCNE2 1.076 GiB
    SPH-L900_1_20170209063552_z21hcd5fc3_fac.zip

    No matching downloads

    How to flash L900VPUCNE2

    • L900VPUCNE2 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    L900VPUCNE2 is Android 4.4.2 (KitKat) firmware for Samsung Galaxy Note II, released for United States (SPR). Samsung built it on 2014-05-07.

    No. A newer build for SPH-L900 is available: L900VPUCOH3. Install it instead of L900VPUCNE2 unless you need this exact version. The previous build was L900VPUBMK4.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.076 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note II must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Note II running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note II

    No changelog details available.
    No changelog details available.
    No changelog details available.
    No changelog details available.
    Model firmware by region