Samsung Galaxy Note 10.1 M486WKAJML3
SHW-M486W 1 country Android 4.1.2 (Jelly Bean)

Samsung Galaxy Note 10.1 M486WKAJML3 Firmware

Samsung Galaxy Note 10.1 M486WKAJML3 is an Android 4.1.2 (Jelly Bean) firmware for South Korea (ANY). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. This is the newest build for SHW-M486W.

9.2/10 (463)4,472 times
Android 4.1.2 (Jelly Bean)
OS Version
2014-01-02
Build Date
n/a
Security patch
1
Countries
1
CSC codes
A (10)
Bootloader binary

Bootloader binary A (10). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: M486WKAJML3
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SHW-M486W
    ANY South Korea
    		M486WANYJMB1 2014-01-02 1.617 GiB
    SHW-M486W_ANY_1_20140103114140_xsj01d3hkr_fac.zip

    No matching downloads

    How to flash M486WKAJML3

    • M486WKAJML3 has bootloader binary A (10). Your device must run binary A (10) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    M486WKAJML3 is Android 4.1.2 (Jelly Bean) firmware for Samsung Galaxy Note 10.1, released for South Korea (ANY). Samsung built it on 2014-01-02.

    Yes. M486WKAJML3 is the newest build for SHW-M486W on SamFirm.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.617 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note 10.1 must be on bootloader binary A (10) or lower.

    This build uses bootloader binary A (10). It can be flashed on a Samsung Galaxy Note 10.1 running binary A (10) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary A (10).

    Other builds and changelog for Samsung Galaxy Note 10.1

    No changelog details available.
    Model firmware by region