GT-N7000 1 country Android 2.3.6 (Gingerbread)

Samsung Galaxy Note N7000UBLS4 Firmware

Name: Samsung Galaxy Note (GT-N7000)
Brand: Samsung
Availability: InStock

Samsung Galaxy Note N7000UBLS4 is an Android 2.3.6 (Gingerbread) firmware for Guatemala (PGU). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N7000UBLR5 https://samfirm.shop/build/N7000UBLR5: Android updated from Ice(Android Cream) to Android 2.3.6 (Gingerbread). A newer build for GT-N7000 is available: N7000ZSLR1 https://samfirm.shop/build/N7000ZSLR1.

9.2/10 (451)4,270 times

Android 2.3.6 (Gingerbread)

OS Version

n/a

Build Date

n/a

Security patch

Countries

CSC codes

U (30)

Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Note use bootloader binary Z (35) (latest: N7000ZSLR1). If your device already runs binary Z (35), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: N7000WELS4

Model	Region	CSC Version	Size	File name	Download
GT-N7000	PGU Guatemala	N7000UWELS1	—	—

How to flash N7000UBLS4

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

N7000UBLS4 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

N7000UBLS4 is Android 2.3.6 (Gingerbread) firmware for Samsung Galaxy Note, released for Guatemala (PGU).

No. A newer build for GT-N7000 is available: N7000ZSLR1. Install it instead of N7000UBLS4 unless you need this exact version. The previous build was N7000UBLR5.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note must be on bootloader binary U (30) or lower.

This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Note running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 8 other builds of this model use the same binary, so you can switch between them in both directions.