Samsung Galaxy Note3 Neo N7507ZTUAOA5
SM-N7507 1 country Android 4.3 (Jelly)

Samsung Galaxy Note3 Neo N7507ZTUAOA5 Firmware

Samsung Galaxy Note3 Neo N7507ZTUAOA5 is an Android 4.3 (Jelly) firmware for Taiwan (BRI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N7507ZTUAOA4, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for SM-N7507.

8.8/10 (451)4,290 times
Android 4.3 (Jelly)
OS Version
n/a
Build Date
n/a
Security patch
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: N7507ZTUAOA5
    ModelRegionCSC VersionSizeFile nameDownload
    SM-N7507
    BRI Taiwan
    		N7507ZZTAOA5 — —

    No matching downloads

    Device specifications

    • Display diagonal14 cm (5.5")
    • Display resolution1280 x 720 pixels
    • Display typeSAMOLED
    • RAM2 GB
    • Rear camera resolution8 MP
    • Rear camera typeSingle camera
    • Battery capacity3100 mAh
    • Weight162.5 g

    Specifications of SM-N7505, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

    How to flash N7507ZTUAOA5

    • N7507ZTUAOA5 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    N7507ZTUAOA5 is Android 4.3 (Jelly) firmware for Samsung Galaxy Note3 Neo, released for Taiwan (BRI).

    Yes. N7507ZTUAOA5 is the newest build for SM-N7507 on SamFirm. The previous build was N7507ZTUAOA4.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note3 Neo must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Note3 Neo running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 3 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note3 Neo

    No changelog details available.
    No changelog details available.
    No changelog details available.
    No changelog details available.
    Model firmware by region