Samsung Galaxy Note4 N910FXXS1CPC5 Firmware
Samsung Galaxy Note4 N910FXXS1CPC5 is an Android 5.1.1 (Marshmallow) firmware for 8 countries, 10 CSC codes. It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N910FXXS1CPC3: Android updated from Android 5.1.1 (Lollipop) to Android 5.1.1 (Marshmallow). A newer build for SM-N910F is available: N910FXXS1PPF1.
9.1/10 (451)56,744 times
Android 5.1.1 (Marshmallow)
OS Version
2016-03-11
Build Date
n/a
Security patch
8
Countries
10
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
Your CSC is in Settings → About phone (About tablet) → Software information, or dial *#1234#. The CSC sets your region's features and network bands. Download the firmware for your country.
13
No matching downloads
Device specifications
- Launched withAndroid 4.4
- Display diagonal14.5 cm (5.7")
- Display resolution2560 x 1440 pixels
- Display typeSAMOLED
- Processor frequency2.7 GHz
- RAM3 GB
- Rear camera resolution16 MP
- Rear camera typeSingle camera
- SIM cardsSingle SIM
- Battery capacity3220 mAh
- Weight176 g
How to flash N910FXXS1CPC5
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- N910FXXS1CPC5 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
N910FXXS1CPC5 is Android 5.1.1 (Marshmallow) firmware for Samsung Galaxy Note4, released for 8 countries, 10 CSC codes. Samsung built it on 2016-03-11.
No. A newer build for SM-N910F is available: N910FXXS1PPF1. Install it instead of N910FXXS1CPC5 unless you need this exact version. The previous build was N910FXXS1CPC3.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note4 must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Note4 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 144 other builds of this model use the same binary, so you can switch between them in both directions.