Samsung Galaxy Note4 N910FXXU1BOE3 Firmware
Samsung Galaxy Note4 N910FXXU1BOE3 is an Android 5.0.1 (Lollipop) firmware for Spain (PHE). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N910FXXU1BOE2: Android updated from Android 5.0.1 (Marshmallow) to Android 5.0.1 (Lollipop). A newer build for SM-N910F is available: N910FXXS1PPF1.
9.3/10 (496)8,635 times
Android 5.0.1 (Lollipop)
OS Version
2015-05-20
Build Date
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
Device specifications
- Launched withAndroid 4.4
- Display diagonal14.5 cm (5.7")
- Display resolution2560 x 1440 pixels
- Display typeSAMOLED
- Processor frequency2.7 GHz
- RAM3 GB
- Rear camera resolution16 MP
- Rear camera typeSingle camera
- SIM cardsSingle SIM
- Battery capacity3220 mAh
- Weight176 g
How to flash N910FXXU1BOE3
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- N910FXXU1BOE3 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
N910FXXU1BOE3 is Android 5.0.1 (Lollipop) firmware for Samsung Galaxy Note4, released for Spain (PHE). Samsung built it on 2015-05-20.
No. A newer build for SM-N910F is available: N910FXXS1PPF1. Install it instead of N910FXXU1BOE3 unless you need this exact version. The previous build was N910FXXU1BOE2.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 2.205 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note4 must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Note4 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 144 other builds of this model use the same binary, so you can switch between them in both directions.