SM-N915F 5 countries Android 6.0.1 (Marshmallow)

Samsung Galaxy Note Edge N915FXXS1DQG2 Firmware

Name: Samsung Galaxy Note Edge (SM-N915F)
Brand: Samsung
Availability: InStock

Samsung Galaxy Note Edge N915FXXS1DQG2 is an Android 6.0.1 (Marshmallow) firmware for 5 countries, 5 CSC codes. It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N915FXXS1DQG1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-N915F is available: N915FXXS1DRI3.

9.1/10 (31)18,161 times

Android 6.0.1 (Marshmallow)

OS Version

2017-07-05

First release

other regions until 2017-08-01

n/a

Security patch

Countries

CSC codes

Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

Not sure which one to download?

Your CSC is in Settings → About phone (About tablet) → Software information, or dial *#1234#. The CSC sets your region's features and network bands. Download the firmware for your country.

Model	Region	CSC Version	MODEM/CP Version	Build Date	Release date	Size	File name
SM-N915F	CAM Cambodia THL Thailand XME Malaysia	N915FOLC1DPE1	N915FXXU1DPD2	2017-08-01	2017-08-03	2.093 GiB	SM-N915F_1_20170801164453_jqo46ibwue_fac.zip
SM-N915F	CAM Cambodia	N915FOLC1DPE1	N915FXXS1DQG2	2017-07-05	—	—	—
SM-N915F	THL Thailand	N915FOLC1DPE1	N915FXXS1DQG2	2017-07-05	—	—	—
SM-N915F	XEV Vietnam XSE Indonesia	N915FOLC1DPE1	N915FXXU1DPD2	2017-07-05	2017-08-03	2.093 GiB	SM-N915F_1_20170904082826_yud49erb7l_fac.zip

Device specifications

Display diagonal14.2 cm (5.6")
Display resolution2560 x 1440 pixels
Display typeSAMOLED
Processor frequency2.7 GHz
RAM3 GB
Rear camera resolution16 MP
Rear camera typeSingle camera
SIM cardsSingle SIM
Battery capacity3000 mAh
Weight174 g

How to flash N915FXXS1DQG2

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

N915FXXS1DQG2 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

N915FXXS1DQG2 is Android 6.0.1 (Marshmallow) firmware for Samsung Galaxy Note Edge, released for 5 countries, 5 CSC codes. Samsung built it on 2017-07-05.

No. A newer build for SM-N915F is available: N915FXXS1DRI3. Install it instead of N915FXXS1DQG2 unless you need this exact version. The previous build was N915FXXS1DQG1.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note Edge must be on bootloader binary 1 or lower.

This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Note Edge running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 104 other builds of this model use the same binary, so you can switch between them in both directions.