Samsung Galaxy Tab 2 7.0 (3G + WiFi) P3100BDCCLL2
GT-P3100B 1 country

Samsung Galaxy Tab 2 7.0 (3G + WiFi) P3100BDCCLL2 Firmware

Samsung Galaxy Tab 2 7.0 (3G + WiFi) P3100BDCCLL2 is an Android firmware for Thailand (THL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P3100BDCBLJ3, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-P3100B is available: P3100BDCCMC1.

9.1/10 (471)4,289 times
n/a
OS Version
2012-12-13
Build Date
n/a
Security patch
1
Countries
1
CSC codes
C (12)
Bootloader binary

Bootloader binary C (12). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: P3100BDCCLK4
    ModelRegionCSC VersionSizeFile nameDownload
    GT-P3100B
    THL Thailand
    		P3100BTHLCLL2 — —

    No matching downloads

    How to flash P3100BDCCLL2

    • P3100BDCCLL2 has bootloader binary C (12). Your device must run binary C (12) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for GT-P3100B is available: P3100BDCCMC1. Install it instead of P3100BDCCLL2 unless you need this exact version. The previous build was P3100BDCBLJ3.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab 2 7.0 (3G + WiFi) must be on bootloader binary C (12) or lower.

    This build uses bootloader binary C (12). It can be flashed on a Samsung Galaxy Tab 2 7.0 (3G + WiFi) running binary C (12) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Tab 2 7.0 (3G + WiFi)

    No changelog details available.
    No changelog details available.
    No changelog details available.
    Model firmware by region