Samsung GT-P5100 P5100UBDLL2 Firmware
Samsung GT-P5100 P5100UBDLL2 is an Android 4.1.2 firmware for Trinidad & Tobago (TTT). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P5100UBBLJ1: Android updated from Android 4.0.4 (Ice Cream Sandwich) to Android 4.1.2. A newer build for GT-P5100 is available: P5100XXDNA1.
8.9/10 (450)4,181 times
Android 4.1.2
OS Version
n/a
Build Date
n/a
Security patch
1
Countries
1
CSC codes
B (11)
Bootloader binary
Bootloader binary B (11). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung GT-P5100 use bootloader binary X (33) (latest: P5100XXDNA1). If your device already runs binary X (33), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: P5100UBLL2
How to flash P5100UBDLL2
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- P5100UBDLL2 has bootloader binary B (11). Your device must run binary B (11) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
P5100UBDLL2 is Android 4.1.2 firmware for Samsung GT-P5100, released for Trinidad & Tobago (TTT).
No. A newer build for GT-P5100 is available: P5100XXDNA1. Install it instead of P5100UBDLL2 unless you need this exact version. The previous build was P5100UBBLJ1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GT-P5100 must be on bootloader binary B (11) or lower.
This build uses bootloader binary B (11). It can be flashed on a Samsung GT-P5100 running binary B (11) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 8 other builds of this model use the same binary, so you can switch between them in both directions.