Samsung GT-P5100 P5100XWALD2 Firmware
Samsung GT-P5100 P5100XWALD2 is an Android 4.2.2 (Jelly) firmware for Italy (WIN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P5100BVDMF1: Android updated from Jelly(Android Bean) to Android 4.2.2 (Jelly); bootloader binary raised from V (31) to W (32), so after installing it there is no way back to older builds. A newer build for GT-P5100 is available: P5100XXDNA1.
9.2/10 (471)4,403 times
Android 4.2.2 (Jelly)
OS Version
2012-04-14
Build Date
n/a
Security patch
1
Countries
1
CSC codes
W (32)
Bootloader binary
Bootloader binary W (32). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung GT-P5100 use bootloader binary X (33) (latest: P5100XXDNA1). If your device already runs binary X (33), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: P5100XXLD6
How to flash P5100XWALD2
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- P5100XWALD2 has bootloader binary W (32). Your device must run binary W (32) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
P5100XWALD2 is Android 4.2.2 (Jelly) firmware for Samsung GT-P5100, released for Italy (WIN). Samsung built it on 2012-04-14.
No. A newer build for GT-P5100 is available: P5100XXDNA1. Install it instead of P5100XWALD2 unless you need this exact version. The previous build was P5100BVDMF1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 996.008 MiB; keep about twice that free on the computer to unzip it. The Samsung GT-P5100 must be on bootloader binary W (32) or lower.
This build uses bootloader binary W (32). It can be flashed on a Samsung GT-P5100 running binary W (32) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 6 other builds of this model use the same binary, so you can switch between them in both directions.