Samsung Galaxy Tab 7.0 Plus (WiFi) P6210ZCLPC Firmware
Samsung Galaxy Tab 7.0 Plus (WiFi) P6210ZCLPC is an Android firmware for China (CHN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P6210XXMF1 https://samfirm.shop/build/P6210XXMF1: bootloader binary raised from X (33) to Z (35), so after installing it there is no way back to older builds. This is the newest build for GT-P6210.
8.7/10 (473)8,824 times
n/a
OS Version
2013-01-17
Build Date
n/a
Security patch
1
Countries
1
CSC codes
Z (35)
Bootloader binary
Bootloader binary Z (35). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: P6210ZCLPC
How to flash P6210ZCLPC
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- P6210ZCLPC has bootloader binary Z (35). Your device must run binary Z (35) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
Yes. P6210ZCLPC is the newest build for GT-P6210 on SamFirm. The previous build was P6210XXMF1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab 7.0 Plus (WiFi) must be on bootloader binary Z (35) or lower.
This build uses bootloader binary Z (35). It can be flashed on a Samsung Galaxy Tab 7.0 Plus (WiFi) running binary Z (35) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary Z (35).
Other builds and changelog for Samsung Galaxy Tab 7.0 Plus (WiFi)
No changelog details available.
- P6210ZCLPCJan 17, 2013
- P6210XXMF1Jun 5, 2013
- P6210XXLPVApr 8, 2013
- P6210UELPCAug 7, 2012
- P6210UBMH1Aug 2, 2013