Samsung GALAXY Tab 8.9 4G P7320TDVLPE
GT-P7320T 1 country

Samsung GALAXY Tab 8.9 4G P7320TDVLPE Firmware

Samsung GALAXY Tab 8.9 4G P7320TDVLPE is an Android firmware for Australia (TEL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. This is the newest build for GT-P7320T.

9.1/10 (471)4,467 times
n/a
OS Version
2013-01-16
Build Date
n/a
Security patch
1
Countries
1
CSC codes
D (13)
Bootloader binary

Bootloader binary D (13). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: P7320TDVLP3
    ModelRegionCSC VersionSizeFile nameDownload
    GT-P7320T
    TEL Australia
    		P7320TTELLP8 — —

    No matching downloads

    How to flash P7320TDVLPE

    • P7320TDVLPE has bootloader binary D (13). Your device must run binary D (13) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    Yes. P7320TDVLPE is the newest build for GT-P7320T on SamFirm.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GALAXY Tab 8.9 4G must be on bootloader binary D (13) or lower.

    This build uses bootloader binary D (13). It can be flashed on a Samsung GALAXY Tab 8.9 4G running binary D (13) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary D (13).

    Other builds and changelog for Samsung GALAXY Tab 8.9 4G

    No changelog details available.
    Model firmware by region