SM-P905 1 country Android 4.4.2 (KitKat)

Samsung Galaxy Note Pro 12.2 P905XXUBML3 Firmware

Name: Samsung Galaxy Note Pro 12.2 (SM-P905)
Brand: Samsung
Availability: InStock

Samsung Galaxy Note Pro 12.2 P905XXUBML3 is an Android 4.4.2 (KitKat) firmware for Italy (ITV). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P905XXUAOB1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for SM-P905.

9.2/10 (451)4,367 times

Android 4.4.2 (KitKat)

OS Version

n/a

Build Date

n/a

Security patch

Countries

CSC codes

U (30)

Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: P905XXUBML3

Model	Region	CSC Version	Size	File name	Download
SM-P905	ITV Italy	P905OXABML3	—	—

Device specifications

Launched withAndroid
Display diagonal31 cm (12.2")
Display resolution2560 x 1600 pixels
Display technologyLCD
Processor frequency2.3 GHz
Rear camera resolution8 MP
Rear camera typeSingle camera
Front camera resolution2 MP
Wi-Fi standardWi-Fi 5 (802.11ac)
Weight753 g

How to flash P905XXUBML3

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

P905XXUBML3 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

P905XXUBML3 is Android 4.4.2 (KitKat) firmware for Samsung Galaxy Note Pro 12.2, released for Italy (ITV).

Yes. P905XXUBML3 is the newest build for SM-P905 on SamFirm. The previous build was P905XXUAOB1.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note Pro 12.2 must be on bootloader binary U (30) or lower.

This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Note Pro 12.2 running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 12 other builds of this model use the same binary, so you can switch between them in both directions.