SM-R775T 1 country

Samsung Gear S3 Classic R775TUVU1FTL2 Firmware

Name: Samsung Gear S3 Classic (SM-R775T)
Brand: Samsung
Availability: InStock

Samsung Gear S3 Classic R775TUVU1FTL2 is an Android firmware for United States (TMB). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build R775TUVU1ETF1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-R775T is available: R775TUVU1FVG1.

9.3/10 (31)244 times

n/a

OS Version

2021-03-26

Build Date

n/a

Security patch

Countries

CSC codes

Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: R775TUVU1FTL2

Model	Region	CSC Version	Size	File name	Download
SM-R775T	TMB United States	R775TTMB1FTL2	677.411 MiB	SM-R775T_1_20210326170535_7u9947la5m_fac.zip

How to flash R775TUVU1FTL2

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

R775TUVU1FTL2 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

No. A newer build for SM-R775T is available: R775TUVU1FVG1. Install it instead of R775TUVU1FTL2 unless you need this exact version. The previous build was R775TUVU1ETF1.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 677.411 MiB; keep about twice that free on the computer to unzip it. The Samsung Gear S3 Classic must be on bootloader binary 1 or lower.

This build uses bootloader binary 1. It can be flashed on a Samsung Gear S3 Classic running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 5 other builds of this model use the same binary, so you can switch between them in both directions.