Samsung GALAXY Pocket Neo S5312CVJS0APL1 Firmware
Samsung GALAXY Pocket Neo S5312CVJS0APL1 is an Android 4.4.2 firmware for Brazil (ZTM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S5312CVJU0AOH1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for GT-S5312C.
9.2/10 (451)4,437 times
Android 4.4.2
OS Version
n/a
Build Date
n/a
Security patch
1
Countries
1
CSC codes
0
Bootloader binary
Bootloader binary 0. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: S5312CVJU0AOH1
How to flash S5312CVJS0APL1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- S5312CVJS0APL1 has bootloader binary 0. Your device must run binary 0 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
S5312CVJS0APL1 is Android 4.4.2 firmware for Samsung GALAXY Pocket Neo, released for Brazil (ZTM).
Yes. S5312CVJS0APL1 is the newest build for GT-S5312C on SamFirm. The previous build was S5312CVJU0AOH1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GALAXY Pocket Neo must be on bootloader binary 0 or lower.
This build uses bootloader binary 0. It can be flashed on a Samsung GALAXY Pocket Neo running binary 0 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.