Samsung Galaxy Y Duos S6102BVJNE1 Firmware
Samsung Galaxy Y Duos S6102BVJNE1 is an Android 2.3.6 (Gingerbread) firmware for Brazil (ZTM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S6102BVJMA2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for GT-S6102B.
9.4/10 (470)4,422 times
Android 2.3.6 (Gingerbread)
OS Version
2014-06-13
Build Date
n/a
Security patch
1
Countries
1
CSC codes
V (31)
Bootloader binary
Bootloader binary V (31). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: S6102BVJND1
How to flash S6102BVJNE1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- S6102BVJNE1 has bootloader binary V (31). Your device must run binary V (31) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
S6102BVJNE1 is Android 2.3.6 (Gingerbread) firmware for Samsung Galaxy Y Duos, released for Brazil (ZTM). Samsung built it on 2014-06-13.
Yes. S6102BVJNE1 is the newest build for GT-S6102B on SamFirm. The previous build was S6102BVJMA2.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 135.681 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Y Duos must be on bootloader binary V (31) or lower.
This build uses bootloader binary V (31). It can be flashed on a Samsung Galaxy Y Duos running binary V (31) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.