GT-S7583T 1 country Android 4.2.2

Samsung GALAXY Trend Plus S7583TDVUBPI1 Firmware

Samsung GALAXY Trend Plus S7583TDVUBPI1 is an Android 4.2.2 firmware for Australia (TLP). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S7583TDVUBPH4, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for GT-S7583T.

9.2/10 (452)4,265 times
Android 4.2.2
OS Version
n/a
Build Date
n/a
Security patch
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: S7583TDVUBPB2
    ModelRegionCSC VersionSizeFile nameDownload
    GT-S7583T
    TLP Australia
    		S7583TTLPBPI1 — —

    No matching downloads

    How to flash S7583TDVUBPI1

    • S7583TDVUBPI1 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    S7583TDVUBPI1 is Android 4.2.2 firmware for Samsung GALAXY Trend Plus, released for Australia (TLP).

    Yes. S7583TDVUBPI1 is the newest build for GT-S7583T on SamFirm. The previous build was S7583TDVUBPH4.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GALAXY Trend Plus must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung GALAXY Trend Plus running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung GALAXY Trend Plus

    No changelog details available.
    No changelog details available.
    Model firmware by region