SC-01D 1 country
Samsung GALAXY Tab 10.1 WIFI SC01DOMMP5 Firmware
Samsung GALAXY Tab 10.1 WIFI SC01DOMMP5 is an Android firmware for Japan (DCM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SC-01D is available: SC01DOMMY1.
9.1/10 (470)4,317 times
n/a
OS Version
2013-07-10
Build Date
n/a
Security patch
1
Countries
1
CSC codes
O (24)
Bootloader binary
Bootloader binary O (24). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: SC01DOMMP5
How to flash SC01DOMMP5
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- SC01DOMMP5 has bootloader binary O (24). Your device must run binary O (24) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
No. A newer build for SC-01D is available: SC01DOMMY1. Install it instead of SC01DOMMP5 unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GALAXY Tab 10.1 WIFI must be on bootloader binary O (24) or lower.
This build uses bootloader binary O (24). It can be flashed on a Samsung GALAXY Tab 10.1 WIFI running binary O (24) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.