Samsung Galaxy Tab 7.7 Plus (DoCoMo) SC01EOMAMF2_DUMMY
SC-01E 1 country

Samsung Galaxy Tab 7.7 Plus (DoCoMo) SC01EOMAMF2_DUMMY Firmware

Samsung Galaxy Tab 7.7 Plus (DoCoMo) SC01EOMAMF2_DUMMY is an Android firmware for Japan (DCM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SC-01E is available: SC01EOMAMF2.

9.0/10 (453)4,403 times
n/a
OS Version
n/a
Build Date
n/a
Security patch
1
Countries
1
CSC codes
D (13)
Bootloader binary

Bootloader binary D (13). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Tab 7.7 Plus (DoCoMo) use bootloader binary M (22) (latest: SC01EOMAMF2). If your device already runs binary M (22), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: SC01EOMMF2
    ModelRegionCSC VersionSizeFile nameDownload
    SC-01E
    DCM Japan
    		SC01EDCMAMF2 — —

    No matching downloads

    How to flash SC01EOMAMF2_DUMMY

    • SC01EOMAMF2_DUMMY has bootloader binary D (13). Your device must run binary D (13) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for SC-01E is available: SC01EOMAMF2. Install it instead of SC01EOMAMF2_DUMMY unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab 7.7 Plus (DoCoMo) must be on bootloader binary D (13) or lower.

    This build uses bootloader binary D (13). It can be flashed on a Samsung Galaxy Tab 7.7 Plus (DoCoMo) running binary D (13) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary D (13).

    Other builds and changelog for Samsung Galaxy Tab 7.7 Plus (DoCoMo)

    No changelog details available.
    Model firmware by region