Samsung Galaxy Note8 SC01KOMU1CSG3 Firmware
Samsung Galaxy Note8 SC01KOMU1CSG3 is an Android 9 (Pie) firmware for Japan (DCM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build SC01KOMU1CSE2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SC-01K is available: SC01KOMU1CZE1.
8.8/10 (452)4,326 times
Android 9 (Pie)
OS Version
2019-07-09
Build Date
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: SC01KOMU1CSG3
How to flash SC01KOMU1CSG3
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- SC01KOMU1CSG3 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
SC01KOMU1CSG3 is Android 9 (Pie) firmware for Samsung Galaxy Note8, released for Japan (DCM). Samsung built it on 2019-07-09.
No. A newer build for SC-01K is available: SC01KOMU1CZE1. Install it instead of SC01KOMU1CSG3 unless you need this exact version. The previous build was SC01KOMU1CSE2.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note8 must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Note8 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 10 other builds of this model use the same binary, so you can switch between them in both directions.