SC-03J 1 country Android 7.0 (Nougat)

Samsung Galaxy S8 Plus (Docomo) SC03JOMU1AQL1 Firmware

Name: Samsung Galaxy S8 Plus (Docomo) (SC-03J)
Brand: Samsung
Availability: InStock

Samsung Galaxy S8 Plus (Docomo) SC03JOMU1AQL1 is an Android 7.0 (Nougat) firmware for Japan (DCM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build SC03JOMU1AQJ2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SC-03J is available: SC03JOMU1CZE1.

8.9/10 (452)8,779 times

Android 7.0 (Nougat)

OS Version

2017-12-04

Build Date

n/a

Security patch

Countries

CSC codes

Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: SC03JOMU1AQL1

Model	Region	CSC Version	Release date	Size	File name	Download
SC-03J	DCM Japan	SC03J1AQL1	—	—	—
SC-03J	DCM Japan	SC03JDCM1AQL1	2017-12-25	3.208 GiB	SC-03J_1_20190103150053_vvc2kn4s1v_fac.zip

How to flash SC03JOMU1AQL1

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

SC03JOMU1AQL1 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

SC03JOMU1AQL1 is Android 7.0 (Nougat) firmware for Samsung Galaxy S8 Plus (Docomo), released for Japan (DCM). Samsung built it on 2017-12-04.

No. A newer build for SC-03J is available: SC03JOMU1CZE1. Install it instead of SC03JOMU1AQL1 unless you need this exact version. The previous build was SC03JOMU1AQJ2.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 3.208 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S8 Plus (Docomo) must be on bootloader binary 1 or lower.

This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy S8 Plus (Docomo) running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 15 other builds of this model use the same binary, so you can switch between them in both directions.