Samsung Galaxy S6 (DoCoMo) SC05GOMU1AOCP
SC-05G 1 country Android 5.0.2 (Nougat)

Samsung Galaxy S6 (DoCoMo) SC05GOMU1AOCP Firmware

Samsung Galaxy S6 (DoCoMo) SC05GOMU1AOCP is an Android 5.0.2 (Nougat) firmware for Japan (DCM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SC-05G is available: SC05GOMU1CRI2.

9.0/10 (455)4,398 times
Android 5.0.2 (Nougat)
OS Version
2015-03-29
Build Date
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: SC05GOMU1AOCP
    ModelRegionCSC VersionSizeFile nameDownload
    SC-05G
    DCM Japan
    		SC05G1AOCP — —

    No matching downloads

    How to flash SC05GOMU1AOCP

    • SC05GOMU1AOCP has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    SC05GOMU1AOCP is Android 5.0.2 (Nougat) firmware for Samsung Galaxy S6 (DoCoMo), released for Japan (DCM). Samsung built it on 2015-03-29.

    No. A newer build for SC-05G is available: SC05GOMU1CRI2. Install it instead of SC05GOMU1AOCP unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S6 (DoCoMo) must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy S6 (DoCoMo) running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 13 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S6 (DoCoMo)

    No changelog details available.
    Model firmware by region