SCV41 1 country Android 10

Samsung Galaxy S10 SCV41KDU1BTC1 Firmware

Samsung Galaxy S10 SCV41KDU1BTC1 is an Android 10 firmware for Japan (KDI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build SCV41KDU1BTB2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SCV41 is available: SCV41KDU1DXJ1.

9.4/10 (455)4,417 times
Android 10
OS Version
2020-03-09
Build Date
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: SCV41KDU1BTC1
    ModelRegionCSC VersionSizeFile nameDownload
    SCV41
    KDI Japan
    		KDU1BTC1QDI1BTC1 — —

    No matching downloads

    How to flash SCV41KDU1BTC1

    • SCV41KDU1BTC1 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    SCV41KDU1BTC1 is Android 10 firmware for Samsung Galaxy S10, released for Japan (KDI). Samsung built it on 2020-03-09.

    No. A newer build for SCV41 is available: SCV41KDU1DXJ1. Install it instead of SCV41KDU1BTC1 unless you need this exact version. The previous build was SCV41KDU1BTB2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S10 must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy S10 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 17 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S10

    No changelog details available.

    · The security of your device has been improved.

    Model firmware by region