Samsung Galaxy Tab3 Lite T110ZSUAND1 Firmware
Samsung Galaxy Tab3 Lite T110ZSUAND1 is an Android 4.2.2 (Jelly) firmware for Taiwan (BRI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build T110XXXUANC7: Android updated from Jelly(Android Bean) to Android 4.2.2 (Jelly). A newer build for SM-T110 is available: T110XXUBNI7.
9.4/10 (470)4,297 times
Android 4.2.2 (Jelly)
OS Version
2014-04-10
Build Date
n/a
Security patch
1
Countries
1
CSC codes
U (30)
Bootloader binary
Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: T110ZSUAND1
Device specifications
- Launched withAndroid
- Display diagonal17.8 cm (7")
- Display resolution1024 x 600 pixels
- Processor frequency1.2 GHz
- Rear camera resolution2 MP
- Rear camera typeSingle camera
- Wi-Fi standardWi-Fi 4 (802.11n)
- Weight310 g
How to flash T110ZSUAND1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- T110ZSUAND1 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
T110ZSUAND1 is Android 4.2.2 (Jelly) firmware for Samsung Galaxy Tab3 Lite, released for Taiwan (BRI). Samsung built it on 2014-04-10.
No. A newer build for SM-T110 is available: T110XXUBNI7. Install it instead of T110ZSUAND1 unless you need this exact version. The previous build was T110XXXUANC7.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 916.053 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Tab3 Lite must be on bootloader binary U (30) or lower.
This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Tab3 Lite running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 30 other builds of this model use the same binary, so you can switch between them in both directions.