Samsung Galaxy Tab3 7.0 T210XXAMGE Firmware
Samsung Galaxy Tab3 7.0 T210XXAMGE is an Android 4.4.2 (Jelly) firmware for Netherlands (PHN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build T210XXAME4, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-T210 is available: T210XXBPJ2.
9.2/10 (451)4,340 times
Android 4.4.2 (Jelly)
OS Version
2015-03-17
Build Date
n/a
Security patch
1
Countries
1
CSC codes
X (33)
Bootloader binary
Bootloader binary X (33). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: T210XXAMGE
Device specifications
- Launched withAndroid
- Display diagonal17.8 cm (7")
- Display resolution1024 x 600 pixels
- Processor frequency1.2 GHz
- Rear camera resolution3 MP
- Rear camera typeSingle camera
- Front camera resolution1.3 MP
- Wi-Fi standardWi-Fi 4 (802.11n)
- Weight300 g
How to flash T210XXAMGE
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- T210XXAMGE has bootloader binary X (33). Your device must run binary X (33) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
T210XXAMGE is Android 4.4.2 (Jelly) firmware for Samsung Galaxy Tab3 7.0, released for Netherlands (PHN). Samsung built it on 2015-03-17.
No. A newer build for SM-T210 is available: T210XXBPJ2. Install it instead of T210XXAMGE unless you need this exact version. The previous build was T210XXAME4.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 823.066 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Tab3 7.0 must be on bootloader binary X (33) or lower.
This build uses bootloader binary X (33). It can be flashed on a Samsung Galaxy Tab3 7.0 running binary X (33) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 28 other builds of this model use the same binary, so you can switch between them in both directions.