SGH-T769 1 country

Samsung Galaxy S Blaze 4G T769UVMH2A Firmware

Samsung Galaxy S Blaze 4G T769UVMH2A is an Android firmware for United States (TMB). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build T769UVMB1: bootloader binary raised from U (30) to V (31), so after installing it there is no way back to older builds. This is the newest build for SGH-T769.

9.1/10 (451)4,462 times
n/a
OS Version
n/a
Build Date
n/a
Security patch
1
Countries
1
CSC codes
V (31)
Bootloader binary

Bootloader binary V (31). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: T769UVMH2
    ModelRegionCSC VersionSizeFile nameDownload
    SGH-T769
    TMB United States
    		T769TMBMH2 — —

    No matching downloads

    How to flash T769UVMH2A

    • T769UVMH2A has bootloader binary V (31). Your device must run binary V (31) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    Yes. T769UVMH2A is the newest build for SGH-T769 on SamFirm. The previous build was T769UVMB1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S Blaze 4G must be on bootloader binary V (31) or lower.

    This build uses bootloader binary V (31). It can be flashed on a Samsung Galaxy S Blaze 4G running binary V (31) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary V (31).

    Other builds and changelog for Samsung Galaxy S Blaze 4G

    No changelog details available.
    No changelog details available.
    Model firmware by region