Samsung Galaxy Tab S 10.5 T800DDU1ANK1 Firmware
Samsung Galaxy Tab S 10.5 T800DDU1ANK1 is an Android 4.4.2 (KitKat) firmware for India (INU). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build T800XXU1ANK1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-T800 is available: T800DDU1CVH2.
9.2/10 (470)4,358 times
Android 4.4.2 (KitKat)
OS Version
2014-11-07
Build Date
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: T800DDU1ANK1
Device specifications
- Launched withAndroid
- Display diagonal26.7 cm (10.5")
- Display resolution2560 x 1600 pixels
- Display technologySuper AMOLED
- Processor frequency1.9 GHz
- Processor familySamsung Exynos
- Processor model5 Octa
- Rear camera resolution8 MP
- Front camera resolution2.1 MP
- Wi-Fi standardWi-Fi 5 (802.11ac)
- Weight465 g
How to flash T800DDU1ANK1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- T800DDU1ANK1 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
T800DDU1ANK1 is Android 4.4.2 (KitKat) firmware for Samsung Galaxy Tab S 10.5, released for India (INU). Samsung built it on 2014-11-07.
No. A newer build for SM-T800 is available: T800DDU1CVH2. Install it instead of T800DDU1ANK1 unless you need this exact version. The previous build was T800XXU1ANK1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.859 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Tab S 10.5 must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Tab S 10.5 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 86 other builds of this model use the same binary, so you can switch between them in both directions.