Samsung Galaxy Tab S3 T827R4TYU3CSI1 Firmware
Samsung Galaxy Tab S3 T827R4TYU3CSI1 is an Android 9 (Pie) firmware for United States (USC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build T827R4TYS3BSD1: Android updated from Android 8.0.0 (Oreo) to Android 9 (Pie). A newer build for SM-T827R4 is available: T827R4TYS3CTC1.
8.9/10 (470)8,788 times
Android 9 (Pie)
OS Version
2019-09-03
First release
other regions until 2019-09-05
n/a
Security patch
1
Countries
1
CSC codes
3
Bootloader binary
Bootloader binary 3. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: T827R4TYU3CSI1
How to flash T827R4TYU3CSI1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- T827R4TYU3CSI1 has bootloader binary 3. Your device must run binary 3 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
T827R4TYU3CSI1 is Android 9 (Pie) firmware for Samsung Galaxy Tab S3, released for United States (USC). Samsung built it on 2019-09-03.
No. A newer build for SM-T827R4 is available: T827R4TYS3CTC1. Install it instead of T827R4TYU3CSI1 unless you need this exact version. The previous build was T827R4TYS3BSD1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 2.661 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Tab S3 must be on bootloader binary 3 or lower.
This build uses bootloader binary 3. It can be flashed on a Samsung Galaxy Tab S3 running binary 3 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.
Other builds and changelog for Samsung Galaxy Tab S3
No changelog details available.
· Device stability improvements, bug fixes.
· New and / or enhanced features.
· Further improvements to performance.