Samsung Galaxy Tab S6 5G T866NKOU3CUC1 Firmware
Samsung Galaxy Tab S6 5G T866NKOU3CUC1 is an Android 11 firmware for South Korea (KOO). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build T866NKOS3BUA1: Android updated from Android 10 to Android 11. A newer build for SM-T866N is available: T866NKOU5DXJ1.
8.7/10 (494)4,351 times
Android 11
OS Version
2021-03-18
Build Date
n/a
Security patch
1
Countries
1
CSC codes
3
Bootloader binary
Bootloader binary 3. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy Tab S6 5G use bootloader binary 5 (latest: T866NKOU5DXJ1). If your device already runs binary 5, this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: T866NKOU3CUC1
How to flash T866NKOU3CUC1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- T866NKOU3CUC1 has bootloader binary 3. Your device must run binary 3 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
T866NKOU3CUC1 is Android 11 firmware for Samsung Galaxy Tab S6 5G, released for South Korea (KOO). Samsung built it on 2021-03-18.
No. A newer build for SM-T866N is available: T866NKOU5DXJ1. Install it instead of T866NKOU3CUC1 unless you need this exact version. The previous build was T866NKOS3BUA1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 4.791 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Tab S6 5G must be on bootloader binary 3 or lower.
This build uses bootloader binary 3. It can be flashed on a Samsung Galaxy Tab S6 5G running binary 3 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 7 other builds of this model use the same binary, so you can switch between them in both directions.
Other builds and changelog for Samsung Galaxy Tab S6 5G
Show 15 older builds
No changelog details available.