Samsung Galaxy Tab S6 T867VVRU7DVC3 Firmware
Samsung Galaxy Tab S6 T867VVRU7DVC3 is an Android 12 firmware for United States (VZW). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build T867VVRS7CVA1: Android updated from Android 11 to Android 12. A newer build for SM-T867V is available: T867VVRUADXJ1.
9.1/10 (468)4,484 times
Android 12
OS Version
2022-03-29
Build Date
n/a
Security patch
1
Countries
1
CSC codes
7
Bootloader binary
Bootloader binary 7. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy Tab S6 use bootloader binary A (10) (latest: T867VVRUADXJ1). If your device already runs binary A (10), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: T867VVRU7DVC3
How to flash T867VVRU7DVC3
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- T867VVRU7DVC3 has bootloader binary 7. Your device must run binary 7 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
T867VVRU7DVC3 is Android 12 firmware for Samsung Galaxy Tab S6, released for United States (VZW). Samsung built it on 2022-03-29.
No. A newer build for SM-T867V is available: T867VVRUADXJ1. Install it instead of T867VVRU7DVC3 unless you need this exact version. The previous build was T867VVRS7CVA1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 5.263 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Tab S6 must be on bootloader binary 7 or lower.
This build uses bootloader binary 7. It can be flashed on a Samsung Galaxy Tab S6 running binary 7 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 4 other builds of this model use the same binary, so you can switch between them in both directions.
Other builds and changelog for Samsung Galaxy Tab S6
Show 15 older builds
No changelog details available.