Samsung SCH-W2013 W2013KEANE2
SCH-W2013 1 country Android 4.0.4 (Ice)

Samsung SCH-W2013 W2013KEANE2 Firmware

Samsung SCH-W2013 W2013KEANE2 is an Android 4.0.4 (Ice) firmware for China (CTC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SCH-W2013 is available: W2013KEAOA1.

9.3/10 (470)4,384 times
Android 4.0.4 (Ice)
OS Version
2014-05-22
Build Date
n/a
Security patch
1
Countries
1
CSC codes
E (14)
Bootloader binary

Bootloader binary E (14). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: W2013KENE2
    ModelRegionCSC VersionSizeFile nameDownload
    SCH-W2013
    CTC China
    		W2013CTCANE2 — —

    No matching downloads

    How to flash W2013KEANE2

    • W2013KEANE2 has bootloader binary E (14). Your device must run binary E (14) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    W2013KEANE2 is Android 4.0.4 (Ice) firmware for Samsung SCH-W2013, released for China (CTC). Samsung built it on 2014-05-22.

    No. A newer build for SCH-W2013 is available: W2013KEAOA1. Install it instead of W2013KEANE2 unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung SCH-W2013 must be on bootloader binary E (14) or lower.

    This build uses bootloader binary E (14). It can be flashed on a Samsung SCH-W2013 running binary E (14) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung SCH-W2013

    No changelog details available.
    No changelog details available.
    Model firmware by region