Samsung Galaxy Tab S9 FE+ 5G X616NKOSCDZD4 Firmware
Samsung Galaxy Tab S9 FE+ 5G X616NKOSCDZD4 is an Android 16 firmware for South Korea (KOO). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build X616NKOSBDZB4: bootloader binary raised from B (11) to C (12), so after installing it there is no way back to older builds. A newer build for SM-X616N is available: X616NKOSGEZI3.
OS updates guaranteed until:
Android 17. Security updates until:
Jul 23, 2028
8.7/10 (24)183 times
Android 16
OS Version
2026-04-24
Build Date
n/a
Security patch
1
Countries
1
CSC codes
C (12)
Bootloader binary
Bootloader binary C (12). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy Tab S9 FE+ 5G use bootloader binary G (16) (latest: X616NKOSGEZI3). If your device already runs binary G (16), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: X616NKOSCDZD4
How to flash X616NKOSCDZD4
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- X616NKOSCDZD4 has bootloader binary C (12). Your device must run binary C (12) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
X616NKOSCDZD4 is Android 16 firmware for Samsung Galaxy Tab S9 FE+ 5G, released for South Korea (KOO). Samsung built it on 2026-04-24.
No. A newer build for SM-X616N is available: X616NKOSGEZI3. Install it instead of X616NKOSCDZD4 unless you need this exact version. The previous build was X616NKOSBDZB4.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 7.481 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Tab S9 FE+ 5G must be on bootloader binary C (12) or lower.
This build uses bootloader binary C (12). It can be flashed on a Samsung Galaxy Tab S9 FE+ 5G running binary C (12) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.